Run Build

Version 4 by Robin Shen
on Jul 28, 2009 17:13.

<< Changes from 3 to 4
compared with
Version 5 by Robin Shen
on Jul 28, 2009 17:20.

Changes from 5 to 6 >>
Key
These lines were removed. This word was removed.
These lines were added. This word was added.

View page history


There are 1 changes. View first change.

 Build can be manually triggered by [running configuration|Run Configuration]. After a build is triggered, it will be put into the queue. If there are no idle threads in the queue, the build will wait until a free thread is available as demonstrated below:
 !run-build.png!
  
 The build will then be put into running status if it is picked up by a free thread in the queue.
 !run-build2.png!
 {warning}The step status graph is only visible to users who are allowed to access build logs.{warning}
   
 After the build finished, the step status graph will disappear from the build overview page. However, it can be brought out by clicking the _steps_ tab like below:
 !run-build3.png!